12v Automatic Tying Machine Handheld Rebar Tier Tying Machine Orange Strapping Machine Tying Range 30-60mm Electric Rebar Bender for Bending Rebar, Steel Bar, Floor Pipe, Steel Rod

Operation Instruction1. The rebar tirer's jaws are stuck to the intersection of the steel bars, and the steel bars are hooked at 45 degree angles.Note: There can be no barrier between the mouth of the jaws and the wire.2. Press the start switch, the rebar tirer machine carries on the work (spins, hinges tightly, cuts off)Note: Press one button at a time, do not probe the jaws at work.3. When automatic completion, the jaw from the steel bar intersection and then pull back, complete the process and prepare for the next binding.4. When the binding process is not completed, do not unplug the machine in advance, otherwise it will cause the bundling of the goods tied skidding.Maintenance1. Clean the machine regularly, keep the wire mouth clean.2. Batteries must not be placed together with other metal objects to avoid short circuit.Safety rules1. In the process of machine bundling, it is strictly forbidden to touch the jaws by hand under any circumstances.3. In the process of machine bundling, it is strictly forbidden to touch the wire disc and wire by hand.4. When the machine sounds an alarm, the machine must be powered off immediately, and then work after the fault is eliminated.5. When inserting the battery, it must be inserted according to the indication of the positive and negative poles.6. Do not allow the battery to be close to high temperature objects such as open flames.7. It is strictly forbidden to expose the battery directly to the humid environment such as rain.8, this product should try to avoid collision, so as not to cause product damage9. This product must be charged using the specified charger and use the specified battery. 11. It is strictly forbidden to connect the battery positive and negative without load.

• 【SPECIFICATION】Color: Orange. Material: Plastic + Metal. Voltage: 12V. Battery: 12V Lithium Ion Batteries. Battery Capacity: 13200 Mah. Battery Charging. Time: 1.5 hours full filling. Tying Wire Diameter: 0.8mm. Tying Wire Length: more than 110m. Applicable Scope Of Steel Strapping: 1.2-2.4inch. Knot Wire Length: 40cm and above. Knot Number Per Charge: 3000 times. Knot The Required Time: 0.8 seconds at a time. Cable Length: 37.40''(appr.). Machine Size:1.42''x2.56''x7.68''.
• 【WIDELY APPLICATION】This steel bar tying machine is a hand-held machine for fast packing steel bars. It is widely used for bending steel bars, steel bars, steel bar binding, floor pipes, heating floor nets, bars, etc. in construction projects.
• 【PORTABLE AND POWER SAVING】This automatic steel bar bending machine is light in weight, small in size, quiet, easy to carry, simple and convenient to operate, easy to bend steel bars, and can be fully charged in only 1.5 hours to reach full power. It is very energy-saving and energy-saving, compared to manual power 3-5 times.
• 【HOW TO USE】The jaws of the reinforced tire tire are glued to the intersection of the steel bars, and the steel bars are hooked at a 45-degree angle. Then press the start switch, and the reinforced tire grinding machine works (rotating, tightening the hinge, cutting off). After all the work is automatically completed, pull the jaws out of the intersection of the steel bars, and then pull them back, and the process is successfully completed.
• [QUALITY ASSURANCE] We have strict quality control system, our products are put into the market after rigorous testing. Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before you order.